Official PayPal Seal
Images may not represent actual product and finish
Images may not represent actual product and finish

AJW UG120-C54 54" Exposed Flange, 1.25" Diameter Grab Bar - Configuration C

Your Price: $38.48
Part Number

:AJW_UG120C54
AJW UG120-C54 54" Exposed Flange, 1.25" Diameter Grab Bar - Configuration C

Attributes

Finish: Satin

Flange: Fabricated of 3" diameter, #11 ga stainless steel with #4 satin finish to match tubing. Flanges are heliarc welded to bar to form a one piece construction. Each flange has three (3) mounting points (1/4" dia.)

Installation: Before installing grab bars, verify with all state and local codes for requirements on bar diameter and type finish. Recommended mounting heights for grab bars are 33" - 36" centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates. Find centerline mounting points and place bar on line making sure to be on center. Transfer mounting points (3 per flange) to wall. Drill pilot holes and secure bar with proper anchors per application.

Standard Lengths ( Other sizes available upon request): 52", 54"

Strength: Bars with a 1 1/2" offset clearance will support loads in excess of 900lbs when properly installed. Bars with greater offsets will support loads up to 250lbs when properly installed.

Tubing: Fabricated of #18 ga stainless steel with a #4 satin finish. Available in 1 1/4" outside diameter. All bends are formed by an automatic mandrel bending process. All bars maintain a constant 1 1/2" offset.

Width: 54"

Resources

Recently Viewed Items